Homeowners can carry out a series of simple tests on a washing machine when it starts to fill water slowly or stops doing so. Knowing how to troubleshoot a leaking washer can save you money and time in the long run. First, disconnect the appliance from the power supply before doing any test on it to avoid electrocution. You might as well turn the water supply off before considering washer repair in Salt Lake City.
Then place a bucket at the back of the washing machine to collect the leaking water. Take time to inspect all water inlets connected to the washer. Splashing water over the appliance can clog the screens with sediments. Try to use a toothbrush to clean the filters and scrape off any sediment buildup. Here is how to troubleshoot a leaking top load washing machine:
Remove the Top Cover
The first step after disconnecting the washer from the power supply is to remove the top cover. Insert a slim, sharp object such as a knife between the front and the top of the washing machine to unlock the top cover. Lift the top lid until the opposite locking tab gets released. Then lift the top cover of the washer until it opens up. Screwdrivers can be used for removing screws that connect the washing machine to the water inlet valves. Then stretch your hand inside the washing machine cabinet and try to lift out the inlet valve.
Grasp the Connectors
The easiest way to disconnect connectors from the terminal is to grasp them and then pull them off. Then refer to the RX1 setting and set the meter before placing the probe on the valve terminal. The readings of the valve should be somehow resistant, and if it isn’t so, consider replacing it.
The Pressure Switch
The next step after grasping the connectors should be to troubleshoot the control console to test the efficiency of the pressure switch. You might have to remove all the knobs from the face of the washer to loosen the console. Remove the screws that are attached to the control console and try to roll it onto the front of the washing machine.
Air Hose Removal
The next step is to disconnect all wire connectors and the air hose from the pressure switch. With the meter of the washing machine set to RX1, link the probe to either of the three terminals. Your pressure should display an infinity reading, and if that’s not the case, consider replacing the pressure switch.
Not all washing machine mechanical problems require the intervention of a repair technician. Fortunately, most leaking cases on washing machines are caused by simple issues. That means homeowners can learn the steps of troubleshooting a leaking washer to keep their appliance performing at its best.
However, an ordinary person might not be sure about what is wrong with their washer if it breaks down. In such a case, consider working with a reputable repair technician. But you can turn to the Internet and watch informative videos on troubleshooting a leaking washing machine. You need to know why your washing machine does not drain before contacting a technician.
